Tag: Michael

Michael is an engineer and friend, and creator of the Cossack design for a red light hat. Using plastic-coated wire mesh for the frame, the Cossack is the best design to use for a DIY light hat. Much better than the bucket-Eliza.

Cossack movie update

Make your own Cossack red light hat.

Making the Cossack Hat Frame*

Michael provided additional information for the DIY Cossack movie.

MEASURE THE CIRCUMFERENCE.

Take a generous length of the hat padding being used, and

  • Fit around the head like a head band.
  • Adjust to fit comfortably around the head and stick together with adhesive tape .
  • Don’t cut the foam yet!
  • Mark the join,
  • Add 2cm to make the band a bit looser, then
  • Cut the padding and tape the ends together to form a circle.

Adjust this head band for easy slip-on comfort and  for it to have a jaunty tilt towards the back of head. Once satisfied with this, measure the final length. This is the final basic circumference for the preparation of the wire mesh frame.

MEASURE THE HEIGHT OF THE HAT.

Like the circumference, this will depend on the individual.

Typically, 9 squares deep (=120mm) is a good height and allows for either an elastic suspension, or for some 6mm foam pads stuck to the top.

A simple paper or cardboard pattern helps to determine these dimensions.

  • Cut a paper pattern 150mm high and the above circumference.
  • Mark the 9 square(120mm) position, and
  • Tape the pattern into a hat shape.
  • Check the height to the top of the head, and
  • Cut the paper to the height needed to fit a padded top for the hat.

         * Wire ends are sharp and can cause cuts. So please wear gloves!

Meet Michael, the Cossack designer.

Here is Michael Richards, wearing his wonderful Cossack light hat.

Michael has been putting together an instruction for a LED-Leg. A few months ago he managed to upset one of his legs by straining his Achilles’ tendon.

He decided to put his red-light making skills into action to fast-track the recovery of his tendon.

And it worked.